A1-154 Girodisc Two-Piece 410mm Front Brake Rotors
FITMENT:
- Porsche GT3 (991) w/ factory PCCB
- Porsche GT3RS (991) w/ factory PCCB
- Porsche GT2RS (991) w/ factory PCCB
- Porsche GT4RS (718) w/ factory PCCB
This 410mm Girodisc conversion system is a direct front rotor replacement for the Porsche 991.1 or 991.2 GT3, GT3RS, GT2RS, and GT4RS originally equipped with PCCB brakes. These two-piece floating iron rotors with aluminum hats will bolt directly to your Porsche and work flawlessly with the OEM front calipers.
You must use must use the pad shape used on the 991 GT3 with iron rotors. The annulus (pad swept height) of these rotors is smaller than the PCCBs to keep rotor weight low and allow far better pad selection.
By upgrading your brakes with lightweight, high-performance Girodisc rotors, especially when paired with Girodisc A2-154 rear rotors, your Porsche's factory brake bias and ABS efficiency are maintained.
The low rotational mass and unsprung weight of Girodisc rotors allows for quick acceleration and fast transient suspension response. Most racers replace the factory PCCBs with Girodisc rotors to avoid the inevitable damage to fragile carbon-ceramic discs when swapping wheels at the track.
We suggest using these rotors with these Pagid 4924 or PFC brake pad profiles normally used in the Porsche 991 GT3 without PCCB. When combined with Competition Motorsport RF1 Racing brake fluid or the New HALO P1 High Performance Brake Fluid, you'll have an extremely reliable and durable solution to cracked or broken carbon-ceramic rotors at a fraction of the cost of factory PCCBs.
The central hat section of the Girodisc is made from 6061-T6 aircraft specification aluminum. The disc is manufactured from cast iron constructed in the USA, made to the same specification with the same material used by professional racing organizations. The rotors' curved vane design was developed in racing and acts as a centrifugal pump to force cooling air through the disc.
The rotor and hat mount together through a floating mount system which utilizes ten high strength alloy steel drive pins manufactured by Girodisc in the USA to their own specifications and are cadmium plated for corrosion resistance. The alloy drive pins transfer the load from the brake action while maintaining the axial and radial float between the disc rotor and hat. The pins are secured by Grade-12 cap screws with hardened washers and mounted with anti-noise spring washers to allow for heat expansion while eliminating the rattle and noise associated with floating rotors.
The two-piece Girodisc design allows for disc-only replacement as well, minimizing future replacement costs and delivering outstanding performance.
Sold/priced per pair.
